A stain on the ceiling directly under the shower
As moisture readings guide drying, escaped pan water follows the joist bay and drops at the first low point it finds, which is rarely under the drain itself.
Source of the water
Artesian, SD
Shower Leak Water Damage in Artesian, SD
Our water-damage technicians cleans up shower leaks and overflows, including moisture behind tile, beneath flooring, and inside nearby wall cavities.
- Restoration phone support around the clock
- Residential and commercial loss response
- Measured extraction, cleanup, and drying
- One restoration team from assessment to dry standard
Signs to look for
When to call us for shower leak cleanup
As moisture readings guide drying, if you notice any of these problems, call us before water has more time to spread into nearby materials.
The floor just outside the shower feels soft or springy
As moisture readings guide drying, water that gets past the pan runs to the edge of the mortar bed and into the subfloor at the threshold.
Tiles in the shower floor sound hollow when tapped
As moisture readings guide drying, run a knuckle across the shower floor and listen for the tone to change from solid to empty.
Grout in the corners and along the curb keeps cracking
From the source check, corners and the curb move slightly with the building, so rigid grout there cracks and reopens.
The ends of the curb are stained or the tile there is loose
Through the final dry check, a shower curb is waterproofed over the top and down both faces, and its two ends are where that wrap is hardest to finish.
Water pools on the bathroom side of the curb after a shower
From the source check, a shower curb is built to shed water back inward, and a door sweep or threshold seal keeps the rest in.
What happens
How we handle shower leak cleanup
Our water-damage technicians adjusts the work to what got wet, how far the water traveled, and which materials can be saved.
Isolating the shower from every other water source in the room
To control the wet boundary, before we look at the pan we rule out the toilet, the sink and the supply lines feeding the shower.
A flood test of the shower pan
To control the wet boundary, the drain is plugged and the pan is filled to just below the curb, then watched over a set period.
A spray test of the walls, curb and door
From the source check, if the pan holds, water is directed at the curb, the corners, the door sweep and the valve trim in turn.
The drain assembly and weep holes checked
Through the final dry check, a traditional pan drains twice: once through the visible drain and once through weep holes at the base of the drain body.
Moisture mapping of the floor, walls and the room below
Through the final dry check, a moisture meter reads the framing, subfloor, wall base and the ceiling underneath, and a thermal imaging camera shows the shape of the wet area.
Tile sounded before anyone talks about removal
As moisture readings guide drying, we tap the shower floor and the lower walls and mark what has debonded.
Talk with a restoration specialist
Water loss in Artesian, SD?
Describe the source, the impacted rooms, and when you first noticed the damage.
What to expect
What to expect from our water-damage technicians
From the source check, here is how we usually handle shower leak cleanup near Artesian, SD.
-
1
Tell us when the water shows up
To control the wet boundary, on the call we ask one question first: does the water appear during a shower, or with nothing running.
Your call -
2
Take that shower out of service
To control the wet boundary, stop using it and use another bathroom if you have one.
+5 minutes -
3
Make the room below safe to be in
To control the wet boundary, if a ceiling is stained or bulging underneath, keep people out from under it and leave the area lit from a doorway.
+10 minutes -
4
Diagnosis on site, starting with the pan
Through the final dry check, a crew arrives, meters the wet area and sets up a flood test on the pan.
On arrival -
5
Openings agreed, then made
To control the wet boundary, we show you where access is needed and why, and we choose the least visible wall wherever the drying allows it.
First hours on site -
6
Equipment aimed into the assembly
From the source check, air movers deliver air into the wall cavity and under the flooring rather than across the room.
Day 1 -
7
Daily readings at the threshold, the cavity and the ceiling
Through the final dry check, the three places that stay wet longest are the subfloor at the shower threshold, the framing behind the surround, and the ceiling below.
Day 2 to 4
Understanding the cost
What can affect the price
As moisture readings guide drying, we explain the recommended work and price before you approve the job. As moisture readings guide drying, these examples show what may change the estimate.
| Common situation | What the estimate may include | Typical range |
|---|---|---|
| Shower leak caught early, drying the floor and wall base only | Through the final dry check, national estimate for diagnosis, testing, drying equipment and monitoring where nothing needs removal. | $500 to $1,500 |
| Wet wall cavity drying behind a tub or shower, one bathroom | As moisture readings guide drying, national estimate for controlled openings, cavity drying and daily readings behind the surround. | $450 to $1,200 |
| Shower leak that reached the subfloor and the ceiling below | From the source check, national estimate covering both rooms, including ceiling material removal, drying and cleaning. | $2,500 to $8,000 |
| Drying priced by affected area, clean water | As moisture readings guide drying, national estimate used when the wet area is measured rather than priced as a room. | $3 to $7 per square foot |
| Tile and mortar bed removal, per square foot | As moisture readings guide drying, national estimate for removal and disposal of tile with a mortar setting bed. | $3.00 to $8.00 |
| Shower pan flood test performed on its own | As moisture readings guide drying, national estimate when the test is the only service requested. | $150 to $400 |
| Shower pan or membrane rebuild by a tile contractor | National estimate for the rebuild trade, not our drying plan. Included so you can see the whole picture. | $1,000 to $4,000 |
How long the shower has been leaking
A few weeks means wet framing and a drying drying plan. A few years means a saturated mortar bed, a spongy subfloor and probably a rebuild.Whether the tile and mortar bed have to come off
Through the final dry check, drying can often be done through a small opening in an adjacent wall or from the ceiling below.Which component actually failed
To control the wet boundary, a door sweep or a caulk joint is a cheap fix once it is proven.Access to the space under the bathroom
Through the final dry check, a basement or crawl space under the shower lets us dry the subfloor and joist bay from below, which is faster and cheaper.How much of the room below is involved
A single stain is a small drying plan. A ceiling that took water across two joist bays brings insulation, light fixtures and paint into the job.Equipment days in a small closed space
Through the final dry check, bathrooms dry well because they are small, but tile and mortar release moisture slowly.
Why timing matters
What can happen when the area stays wet
To control the wet boundary, water can keep moving into nearby materials even when the surface looks dry.
Every shower adds to the loss
As moisture readings guide drying, unlike a burst pipe, this leak is switched on by the household.
The subfloor at the threshold loses strength
As moisture readings guide drying, plywood that goes through repeated wet and dry cycles delaminates in layers.
The mortar bed stays saturated and stops holding tile
As moisture readings guide drying, a mortar bed sitting on a failed liner acts like a sponge that never gets to dry.
Mold can start within 24 to 48 hours inside the wall
To control the wet boundary, a wall cavity behind a shower is warm, dark and repeatedly rewetted, which is a favorable set of conditions.
Helpful service information
What to know about shower leak cleanup
From the source check, start with the short explanation. To control the wet boundary, open a card if you want a little more detail.
What is happening inside the property
Through the final dry check, at the bottom sits the preslope, a sloped bed that sends water toward the drain.
Read the explanation
Through the final dry check, a tile shower is a stack of layers, and knowing the stack explains every failure.
How the next step is decided
To control the wet boundary, grout and tile are the wear surface, not the seal, and water passes through both slowly by design.
Read the explanation
To control the wet boundary, the grout myth costs homeowners more money than any other idea in bathroom repair.
What may change the work
From the source check, mortar and tile hold moisture and release it gradually, so the room air can read normal while the setting bed is still saturated.
Read the explanation
As moisture readings guide drying, drying a shower leak is different from drying a burst pipe, because the wet material is enclosed and slow.
Help near you
Shower Leak Water Damage near Artesian, SD
Choose your area below, or call (877) 734-0262 and describe what happened.
Common questions
Questions about shower leak cleanup
How do I know if my shower pan is leaking?
From the source check, timing is the first clue. Through the final dry check, if water appears during or shortly after a shower and nothing shows with the water off, the assembly is leaking rather than a pipe.
Is my grout supposed to be waterproof?
From the source check, no, and this is the most common misunderstanding in shower repair. To control the wet boundary, grout is a filler between tiles and it is porous by design.
Can you fix a shower pan leak without removing the tile?
As moisture readings guide drying, sometimes the leak is at the curb, the door sweep, the valve trim or a corner joint, and those are repaired without touching the floor.
What is a shower pan flood test?
To control the wet boundary, the drain is plugged, the pan is filled with water to just below the curb, and the level is marked and watched over a set period.
What are weep holes and why do they matter?
From the source check, a traditional shower drain has small openings at its base that let water sitting on the pan liner escape into the drain.
Through the final dry check, there is a stain on the ceiling under my shower. How bad is it?
Through the final dry check, check whether it darkens after a shower and fades between them, which points at the shower rather than a pipe.
How long does it take to dry a shower leak?
Through the final dry check, three to five days is typical once the source is stopped and the equipment is in.
Talk with a restoration specialist
Water loss in Artesian, SD?
Describe the source, the impacted rooms, and when you first noticed the damage.
Areas we serve
Water-damage help near Artesian, SD
Our water-damage technicians trace homes, businesses, and managed properties throughout Artesian, SD and nearby communities.
View the area on Google Maps